Rvision SEE, Руководство по установке и эксплуатации

Страница: 47 / 64

RVision P/N
660904-01
Rev 1 A-
1
Appendix A – Setting up the SEE™ IP Camera
This appendix contains the procedure to setup, configure and use your SEE™-IP
camera.
Changing the Camera IP Address
The SEE™-IP cameras have the IP address preset at the factory. To change the
address perform the following steps.
1. In this procedures, assume a factory default setting of 192.168.10.XXX. The XXX
digits vary between cameras.
To communicate with the camera you must set the computer’s IP address to be a
static IP (other than the camera IP) using the same subnet and gateway of the
camera.
2. Open the computers Control Panel and select Network
Figure 40 : Control Panel
3. The Network Connections page is displayed. Click on the network connected to
the camera (usually the Local Area Connection).
Figure 41: Network connections