Rvision SEE, Руководство по установке и эксплуатации

Страница: 50 / 64

A-4
RVision P/N
660904-01
Rev 1
SEE™ Setting up the SEE™ IP Camera
Multicast Mode
Within a network that supports multicasting, a large number of decoders can be
used to receive video effectively from a SEE™IP using a single stream each of video
and audio.
Connect SEE™IP to LAN
192.168.10.100 is the default factory IP address setting of the SEE™IP.
To integrate the SEE™ IP into a network with this address refer to the Setting up the
Network Configuration section for detailed instructions.
Connecting the RJ45 connector to a PC
The SEE™ IP connects to a PC through the Ethernet port using the cable assembly in
Figure 45.
Figure 45: SEE™ IP Cable
Setting up the Network Configuration
Only the parameters that fall within the Fixed IP condition are recommended and
supported. Contact your network administrator to determine the proper network set-
ting for your camera.
QuickConnect
Mount
RJ45
Ethernet
connector DC
polarized
power
plug