Rockwell ArmorStratix 5700 series, Инструкция по эксплуатации

Страница: 30 / 548

30 Rockwell Automation Publication 1783-UM007F-EN-P - September 2016
Chapter 2 Get Started
Express Setup Overview When you first install the switch, use Express Setup to perform these initial
setup tasks:
• Assign the switch an initial IP address. You can then access the switch
through the IP address for more configuration.
• Run the global macro to set initial configuration parameters, as
described on page 43 .
Express Setup Requirements
Multi-mode and single-mode versions of Express Setup are available depending
on your switch and IOS version:
• With IOS version
15.2(4)EA3 or later
, the following switches use
multi-mode Express Setup, as described on page 34 :
– Stratix® 5400
– Stratix 5410
– Stratix 5700
– ArmorStratix™ 5700
– Stratix 8000
• With IOS version
15.2(4)EA or earlier
, all switches use single-mode
Express Setup, as described on page 38 .
• All IOS versions of the Stratix 8300 switch use single-mode Express
Setup.
Multi-mode Express Setup enables you to configure network settings in either
Device Manager or the Studio 5000 Logix Designer® application. To configure
network settings via the Logix Designer application, you must have the Add-on
Profile (AOP) for Stratix switches,
version 11.01.xx or later
.