7. MODBUS
IMS01J02-E4
133
Continued from the previous page.
Name
Attri-
bute
Struc-
ture
Data range
Factory
set value
Start determination
point
1
[H-TIO-
, H-CIO-A]
R/W C
0.0 to 100.0
of span (Deviation setting
from the temperature set value)
Setting will be invalid in H-SIO-A module.
3.0
Control RUN/STOP
holding
2
[H-PCP-J]
R/W U
0: Not hold
Start-up from control stop status
1: Hold
Start-up from before the stop status
2: Start-up from control run status
1
1
On restarting after power failure, if the temperature measured value (PV) is within the setting range
by the start determination points, the hot start will definitely be carried out. If the temperature
measured value (PV) is outside this range, the operation will begin with the start condition with was
selected by the Hot/Cold start selection (Identifier: XN).
2
Action after power-ON differs depending on control RUN/STOP holding (Identifier: X1) setting.
Control RUN/STOP
holding
Status after power-ON
Operation mode transfer
(See P. 125)
Control RUN/STOP transfer
(See P. 127)
0: Not hold
Same as mode before the power
failure
“0: Control STOP”
Stopped until “1: Control RUN”
is instructed from the PLC or host
computer.
1: Hold
Same as mode before the power
failure
Same as status before the power
failure
Control before power failure is
maintained even if no PLC or
host computer is connected.
2: Start-up from control run
status
“1: Monitor” mode
However if the operation mode is
set to “0: Unused,” “0: Unused”
remains unchanged.
“1: Control RUN”
However, no control is performed
until the operation mode is set to
“3: Normal (perform control).”
Continued on the next page.
Plus side start
determination point
Minus side start
determination point
The start condition with
was selected by the
Hot/Cold start selection
The start condition with
was selected by the
Hot/Cold start selection
Forced hot start
Temperature set value
(SV)
Start determination
range
