RITE-HITE DUAL-DOK 2200, Руководство пользователя

Страница: 25 / 84

BELOW DOCK END LOAD IN LEVELER
MODE
NOTE:
Figure 26 shows the control box front view.
1. Change the outside light to RED. Small LED lights
located in the lower corner of the control box will
show the operator if the outside lights are RED or
GREEN.
2. Push and immediately release (pulse) the RAISE
button. See Figure 23.
3. When loading or unloading is complete, push and
immediately release (pulse) the RAISE button again
to return the DUAL-DOK to the store platform. See
Figure 20.
4. Change the outside light to GREEN.
Pub. No. 1290 - January 2010
25
RITE-HITE ® Dual-Dok ® Combined Lift & Leveler System Owner’s Manual
OPERATION INSTRUCTIONS CONTINUED
Control
Box
Outside Lights
Red
Green
Truck Bumper
• To change unit to Lift Mode, push and release
"DOWN"
button with no
load on platform.
• Do not place load on plaftorm unless unit is in Lift Mode.
• When lift operations are complete, always return platform to dock height.
Push and release leveler "RAISE" button to change unit to Leveler Mode.
A pulsing horn indicates that the platform has been below dock for 15
minutes.
MANUAL FUNCTIONS
Leveler Raise: Disengage Pins
Lip Extend: Extend Lip
Auto-Lip: Unlock Velocity Fuse
Lift Up: Raise Lift
Lift Down: Lower Lift
Press "MANUAL/RESET" button to reset
DUAL-DOK after a fault has been cleared at
dock height. If a fault has been cleared below
dock height, press "MANUAL/REST" button and
corresponding manual function button to move
unit to dock height.
ADDITIONAL WARNINGS AND INSTRUCTIONS ON SIDE OF ENCLOSURE
1. Do not operate leveler with anyone standing on or in front of leveler.
2. Do not operate in any mode with anyone standing under or in front of leveler.
3. Never enter a truck/trailer until its brakes are set, air has been dumped from air ride suspension (if applicable), and you have visually inspected to be sure truck/trailer is
securely held in place by a vehicle restraint or wheel chock per OSHA regulations.
• Outside light is on when LED flashes.
• Check outside lights is both LEDs are off.
• The outside light switch must be
turned to RED to operate the system.
Do not turn switch to GREEN unit
loading/unloading is complete.
Verify that the platform is at dock height and that no load is on
platform. Push to Raise platform.
Push and hold "MOMENTARY PAUSE"
to pause any movement of platform
and lip. Release to continue operation.
• To position for below dock
endload, Push and release
"RAISE" button.
• To store from below dock
endload, Push and
immediately release (pulse)
"RAISE" button.
Push both to extend lip. Release both to lower leveler onto trailer.
• In Auto-Lip mode, lip
automatically extends
whenever the
"DOWN" button
is pushed.
• To engage Auto-Lip, push
and release
"AUTO-LIP"
button with platform at dock
height.
• To cancel Auto-Lip, push and
relase
"AUTO-LIP" button
with platform at dock height.
Push to lower lift.
Push to raise lift.
MANUAL/RESET
PAUSE
MOMENTARY
END LOADING
LIP EXTEND
LEVELER RAISE
LIFT DOWN
LIFT UP AUTO-LIP
OUTSIDE LIGHT
WARNING
WARNING
Lip
Platform
LEVELER LIFT
MILWAUKEE, WISCONSIN 1-800-456-0600 COMBINED LIFT & LEVELER SYSYEM 0126280 REV
. X
X
R R
F1 F2 F3 F4
FIGURE 23 - BELOW DOCK END LOAD
In Leveler Mode, the DUAL-DOK should not be
raised or lowered to an operating position with
a load on the platform. When in Leveler Mode,
pushing the RAISE button will cause the unit to
descend momentarily and perform a weight
check. Operation will then continue. In Lift or
Auto-lip Modes, the platform may be raised or
lowered under a load.