RITE-HITE DUAL-DOK 2200, Руководство пользователя

Страница: 23 / 84

Pub. No. 1290 - January 2010
23
NOTE:
Figure 26 shows the control box front view.
1. Change the outside light to RED. Small LED lights
located in the lower corner of the control box will
show the operator if the outside lights are RED or
GREEN.
2. Push and hold the RAISE button. The platform will
lower slightly and then return to dock level checking
for weight on the platform. Continue to hold the
RAISE button. If no weight is detected, the platform
will continue to raise to its fully extended position
and the lip will automatically extend.
3. Release the RAISE button after the lip is fully
extended. The leveler will descend and the lip will
rest on the trailer floor. See Figure 21.
RITE-HITE ® Dual-Dok ® Combined Lift & Leveler System Owner’s Manual
OPERATION INSTRUCTIONS
Control
Box
Outside Lights
Red
Green
Pendant Lip
• To change unit to Lift Mode, push and release "DOWN" button with no
load on platform.
• Do not place load on plaftorm unless unit is in Lift Mode.
• When lift operations are complete, always return platform to dock height.
Push and release leveler "RAISE" button to change unit to Leveler Mode.
A pulsing horn indicates that the platform has been below dock for 15
minutes.
MANUAL FUNCTIONS
Leveler Raise: Disengage Pins
Lip Extend: Extend Lip
Auto-Lip: Unlock Velocity Fuse
Lift Up: Raise Lift
Lift Down: Lower Lift
Press "MANUAL/RESET" button to reset
DUAL-DOK after a fault has been cleared at
dock height. If a fault has been cleared below
dock height, press "MANUAL/REST" button and
corresponding manual function button to move
unit to dock height.
ADDITIONAL WARNINGS AND INSTRUCTIONS ON SIDE OF ENCLOSURE
1. Do not operate leveler with anyone standing on or in front of leveler.
2. Do not operate in any mode with anyone standing under or in front of leveler.
3. Never enter a truck/trailer until its brakes are set, air has been dumped from air ride suspension (if applicable), and you have visually inspected to be sure truck/trailer is
securely held in place by a vehicle restraint or wheel chock per OSHA regulations.
• Outside light is on when LED flashes.
• Check outside lights is both LEDs are off.
• The outside light switch must be
turned to RED to operate the system.
Do not turn switch to GREEN unit
loading/unloading is complete.
Verify that the platform is at dock height and that no load is on
platform. Push to Raise platform.
Push and hold "MOMENTARY PAUSE"
to pause any movement of platform
and lip. Release to continue operation.
• To position for below dock
endload, Push and release
"RAISE" button.
• To store from below dock
endload, Push and
immediately release (pulse)
"RAISE" button.
Push both to extend lip. Release both to lower leveler onto trailer.
• In Auto-Lip mode, lip
automatically extends
whenever the
"DOWN" button
is pushed.
• To engage Auto-Lip, push
and release
"AUTO-LIP"
button with platform at dock
height.
• To cancel Auto-Lip, push and
relase
"AUTO-LIP" button
with platform at dock height. Push to lower lift.
Push to raise lift.
MANUAL/RESET
PAUSE
MOMENTARY
END LOADING
LIP EXTEND
LEVELER RAISE
LIFT DOWN
LIFT UP AUTO-LIP
OUTSIDE LIGHT
WARNING
WARNING
Lip
Platform
LEVELER LIFT
MILWAUKEE, WISCONSIN 1-800-456-0600 COMBINED LIFT & LEVELER SYSYEM
0126280 REV
. X X
R R
F1 F2 F3 F4
FIGURE 20 - STORED POSITION
Control
Box
Outside Lights
Red
Green
Extended Lip
• To change unit to Lift Mode, push and release "DOWN" button with no
load on platform.
• Do not place load on plaftorm unless unit is in Lift Mode.
• When lift operations are complete, always return platform to dock height.
Push and release leveler "RAISE" button to change unit to Leveler Mode.
A pulsing horn indicates that the platform has been below dock for 15
minutes.
MANUAL FUNCTIONS
Leveler Raise: Disengage Pins
Lip Extend: Extend Lip
Auto-Lip: Unlock Velocity Fuse
Lift Up: Raise Lift
Lift Down: Lower Lift
Press "MANUAL/RESET" button to reset
DUAL-DOK after a fault has been cleared at
dock height. If a fault has been cleared below
dock height, press "MANUAL/REST" button and
corresponding manual function button to move
unit to dock height.
ADDITIONAL WARNINGS AND INSTRUCTIONS ON SIDE OF ENCLOSURE
1. Do not operate leveler with anyone standing on or in front of leveler.
2. Do not operate in any mode with anyone standing under or in front of leveler.
3. Never enter a truck/trailer until its brakes are set, air has been dumped from air ride suspension (if applicable), and you have visually inspected to be sure truck/trailer is
securely held in place by a vehicle restraint or wheel chock per OSHA regulations.
• Outside light is on when LED flashes.
• Check outside lights is both LEDs are off.
• The outside light switch must be
turned to RED to operate the system.
Do not turn switch to GREEN unit
loading/unloading is complete.
Verify that the platform is at dock height and that no load is on
platform. Push to Raise platform.
Push and hold "MOMENTARY PAUSE"
to pause any movement of platform
and lip. Release to continue operation.
• To position for below dock
endload, Push and release
"RAISE" button.
• To store from below dock endload, Push and
immediately release (pulse)
"RAISE" button.
Push both to extend lip. Release both to lower leveler onto trailer.
• In Auto-Lip mode, lip
automatically extends
whenever the
"DOWN" button
is pushed.
• To engage Auto-Lip, push
and release
"AUTO-LIP"
button with platform at dock
height.
• To cancel Auto-Lip, push and
relase
"AUTO-LIP" button
with platform at dock height.
Push to lower lift.
Push to raise lift.
MANUAL/RESET
PAUSE
MOMENTARY
END LOADING
LIP EXTEND
LEVELER RAISE
LIFT DOWN
LIFT UP AUTO-LIP
OUTSIDE LIGHT
WARNING
WARNING
Lip
Platform
LEVELER LIFT
MILWAUKEE, WISCONSIN 1-800-456-0600 COMBINED LIFT & LEVELER SYSYEM 0126280 REV
. X
X
R R
F1 F2 F3 F4
FIGURE 21 - LEVELER MODE
Before loading/unloading operations begin,
secure the truck with wheel chocks or a vehicle
restraint and turn the outside light selector
switch to RED. See Figure 20. The LED will
change from GREEN position to the RED. No
controls will function until the outside light has
been changed to RED.
In Leveler Mode, the DUAL-DOK should not be
raised or lowered to an operating position with
a load on the platform. When in Leveler Mode,
pushing the RAISE button will cause the unit to
descend momentarily and perform a weight
check. Operation will then continue. In Lift or
Auto-lip Modes, the platform may be raised or
lowered under a load.