Riken Keiki GD-3EC, Техническое руководство

Страница: 70 / 177

4. Installation 4-7 Connecting the power and signal cables
70 / 168
4-7-5 Connecting cables to the terminal plate
Strip the cable to the specified length and connect to the cable wire insertion holes on the terminal plate.
<Terminal plate specifications>

Rated voltage: 300 V AC

Rated current: 10 A
Specifications will vary depending on the cable used.
<Connecting conditions>

Cable used: 0.25 mm
2
- 2.5 mm
2

Maximum sheathing external diameter: 4.1 mm

Stripped wire (conductor) length: 8 mm - 9 mm (9 mm - 10 mm for SD-3 TN1 only)

Connecting tool: Flathead screwdriver (blade tip 2.5 mm × 0.5 mm) or operating lever (provided)
CAUTION
Be sure to strip the cable to the specified (conductor) length.

Conduction faults or overheating may result if the stripped wire (conductor) length is too short and the
wire is clamped incorrectly.

Conduction faults or overheating may result if the stripped wire (conductor) length is too short and the
wire sheathing is clamped.

An insulation failure or short circuit may result if the stripped wire (conductor) length is too long and the
wire is exposed.

Make sure the wire does not splay. An insulation failure or overheating may result if the wire splays when
inserted.

To avoid the above, if the stripped wire is stranded wire cable, we recommend using a bar terminal
(ferrule).
<Compatible rod terminal>
If you use rod terminals, use the following item:

Rod terminal (ferrule): Model 216 series (manufactured by WAGO)

Crimping tool: Model Variocrimp 4 (206-1204) (manufactured by WAGO)
CAUTION

Be sure to use the specified rod terminals. We cannot guarantee performance if you use rod terminals
other than those specified.
9 mm - 10 mm