Riken Keiki GD-3EC, Техническое руководство

Страница: 71 / 177

4. Installation 4-7 Connecting the power and signal cables
71 / 168
Operating
lever
Wire insertion
hole
Cable
Screwdriver slot
<Connecting cables to terminal plate>
To connect cables to the terminal plate, use the operating lever provided as a standard accessory or a flathead
screwdriver (blade tip 2.5 mm × 0.5 mm).
The operating lever provided as a standard accessory cannot be used when connecting power and signal
cables to TN1 on the SD-3. Use a flathead screwdriver in this case.
CAUTION

Be sure to use the correct tools.

As a rule, only one cable can be connected to each wire insertion hole.

If a cable is inserted into the screwdriver slot, the conductor may not make contact, resulting in
conduction faults or overheating.
When using the operating lever provided as a standard accessory, connect the cable to the terminal plate as
follows.
1 Hook the operating lever on to the screwdriver
slot (rectangular hole) in the terminal plate as
shown in the figure to the right.
2 Push the operating lever with your finger to push
down the spring inside the terminal plate.
3 While continuing to press the operating lever, insert
the cable into the wire insertion hole (round hole)
until it contacts the end.
4 Release the operating lever.
The cable is now connected to the terminal plate.
Gently pull on the cable to confirm that it is correctly connected.
Avoid pulling with excessive force.