Ricoh SCRIPT2, Руководство по установке

Страница: 304 / 406

Appendix
78
6
Assigning IP Address with ARP+PING
Using TCP/IP, you can assign the IP address using ARP and PING. The follow-
ing example is for a BSD UNIX workstation (SunOS 4.x).
Preparation
ARP+PING should be set to active on the network boot configuration before
assigning the IP address using ARP+PING. For more information about set-
ting it to active, see the Setup Guide that comes with this printer.
A
Log on to the workstation as root.
B
Use the arp command to assign the IP address to the MAC address of the
Network Interface Board.
# arp -s 192.168.15.16 00:00:74:62:5C:65
Note
❒
192.168.15.16 is the IP address, 00:00:74:62:5C:65 is the MAC address.
C
Assign the IP address using the ping command.
# ping 192.168.15.16
D
Use the ping command again to confirm the address.
# ping 192.168.15.16
If the address has been configured correctly, the following message appears.
192.168.15.16 is alive
If the address has been configured incorrectly, the following message ap-
pears.
no answer from 192.168.15.16
- - - -
How to Confirm the MAC Address
The MAC address (Ethernet address) of the Network Interface Board is required
in order to use ARP and PING to assign the IP address.
The MAC address can be seen on the network configuration page.
Reference
For how to print the network configuration page, see P.108 “Network Config-
uration Page” .
Note
❒
The MAC address can also be seen on the printer configuration page. For
more information about the printer configuration page, see the Setup Guide
that comes with this printer.