Ricoh SCRIPT2, Руководство по установке

Страница: 259 / 406

Configuring the Protocols
33
3
Configuring the Protocols
Configuring TCP/IP and IPP for Printing
Follow these instructions to configure the Network Interface Board and Win-
dows NT to use the TCP/IP protocol and IPP.
Configuring the printer
Configure the printer to use the TCP/IP protocol.
• Confirm that the TCP/IP protocol is set to be active. (The factory default is active.)
• Assign an IP address and make other settings required for using the TCP/IP
protocol.
Reference
For more information about how to make the above settings, see the Setup
Guide that comes with this printer.
If DHCP is used to assign IP addresses, see P.104
“When Using DHCP” .
Note
❒
After setting the IP address, use the ping command to confirm that it has been
set correctly.
A
Click [ Start ] , point to [ Programs ] , and then click [ Command Prompt ] .
B
Type the following. (Example IP address is 192.168.15.16)
C:> ping 192.168.15.16
If the address has been configured correctly, the following message ap-
pears.
Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32
If the address has been configured incorrectly, the following message ap-
pears.
Request timed out.
Configuring a Windows NT computer
Follow these steps to configure a Windows NT computer to use the TCP/IP pro-
tocol.
A
Open
[ Control Panel ]
and double-click the
[ Network ]
icon. Confirm that “TCP/
IP Protocol” is listed in the [ Network protocols ] box on the [ Protocols ] tab.
Note
❒
If the TCP/IP protocol is not installed, click [ Add ] on the [ Protocols ] tab and
install it. For more information about installing the TCP/IP protocol, see
Windows NT Help.