Ricoh SCRIPT2, Руководство по установке

Страница: 152 / 406

Troubleshooting
68
4
F
Close the front cover. Press the
center of the cover until it locks
securely into place.
The “Add Toner” message clears
from the panel display and the
printer starts warming up.
Replacing the Photoconductor
Unit
The message shown below indicates
that the photoconductor unit is ap-
proaching the end of its life.
IPDL-C
Change PCU
You can still continue to use the cur-
rent photoconductor unit if you are
satisfied with the quality of the out-
put being produced by the printer.
When the printed image starts look-
ing soiled (horizontal lines along the
edges of the page, for example), re-
place the photoconductor unit as
soon as possible.
R
WARNING:
R
CAUTION:
Important
❒
Exposing the photoconductor unit
to light for too long can reduce its
performance. Replace the unit as
quickly as possible.
❒
Do not touch the surface of the
photoconductor unit. If you do, it
may damage the photoconductor
unit and reduce the print quality.
❒
Do not expose the photoconductor
unit to a light source greater than
800 luxes for more than two min-
utes. If you do, the photoconductor
unit will be damaged and the print
quality might be reduced.
ZDGH012J
• Do not incinerate the photo-
conductor unit. Toner dust
might ignite when exposed to
an open flame.
• Disposal can take place at our
authorized dealer or at appro-
priate collection sites.
• If you dispose the used photo-
conductor unit yourself, dis-
pose of it according to your
local regulations.
• When accessing the inside of
the machine, do not touch any
sections other than those
specified in this manual. If you
do, it might result in receiving
a burn or injury.
• Do not open the front cover
when the paper tray is pulled
out halfway. If you do, it might
cause a personal injury.