REICH MOVE CONTROL ECONOMY LIGHT, Инструкция по установке и эксплуатации

Страница: 24 / 56

For the removal disconnect the drive units in
reverse order as described.
Ensure that the friction rollers are completely
driven back and the green marking can be seen
no more
7
(= OFF).
B3 Undo the handbrake of your caravan.
Caution: Read the FAQs (A4) when the drive
rollers do not turn.
The drive units must not be left connected to the
tyres for long periods of time, as this can result in
damage to the tyres. Movement with a motor
vehicle while the drive units are connected is not
allowed, as the caravan or trailer as well as the
motor vehicle can be damaged.
Turn OFF the isolation switch
.
Pull on the handbrake and/or secure your caravan
or trailer against rolling away with the help of
chocks.
GB6
E
n
g
lis
h
6. Operation
You can now manoeuvre according to
the symbols shown on the remote con-
trol. The vehicle only moves as long as
you are holding one of the buttons.
The remote control automatically switches off and
has to be switched on again when you do not
press a button within 60 seconds.
Activate the MoveControl with a double-
click on the I/O button on the remote
control.
All status LEDs will light up in short
sequence. A short signal sound and the
continuously lit trailer symbol indicate
readiness for operation.
Check whether the MoveControl is oper-
ational by pressing the buttons on the
remote control.
ON
OFF
Move your caravan or trailer into the open. We
recommend using a spacious area with sufficient
safety distance to persons and objects until you
are practised in manoeuvring with the MoveCon-
trol.
Take care that no persons remain in the
manoeuvring range of the trailer or cara-
van during manoeuvring!
Also check the side of the caravan or trailer oppo-
site you.
Keep a sufficient safety distance while manoeu-
vring.
Always remain at a sufficient distance to
the drive rollers, also during maintenance
or cleaning work.
Switch the system to a current-free state and
secure the vehicle against rolling before working
in the area of the drive rollers.
B1 Switching on the system
Switch on the main switch. Ensure that all
drive units are uncoupled from the vehicle
tyres.
B2 Swivelling on / -off the drive rollers
Put a suitable key or adapter (19 mm) on the
hexagonal bolt in the lateral opening of the
drive protective cover. Turn the spindle as
long enough until you can see the green
marking completely
(= ON). An additional
mechanical stroke signals the respective final
position.