R&S FSMR3000, Руководство пользователя

Страница: 687 / 733

Remote Commands
R&S
®
FSMR3000
687 User Manual 1179.0116.02 ─ 02
TRIGger[:SEQuence]:SOURCe EXTernal | IMMediate | VIDeo | LINE | EXTernal1 | EXT1 | EXTernal2 |
EXT2 | RFBurst | FRAMe
TRIGger[:SEQuence]:VIDeo:DELay[?] <time>
TRIGger[:SEQuence]:VIDeo:DELay:STATe[?] OFF | ON | 0 | 1
TRIGger[:SEQuence]:VIDeo:LEVel[?] <ampl>
TRIGger[:SEQuence]:VIDeo:SLOPe[?] POSitive | NEGative
12.12 Using the Status Register
For more information on the contents of the status registers see:
●
Remote control via SCPI
●
Chapter 11.2.2.4, "STATus:OPERation Register" , on page 327
●
Chapter 11.2.2.6, "STATus:QUEStionable:ACPLimit Register" , on page 329
●
Chapter 11.2.2.7, "STATus:QUEStionable:EXTended Register" , on page 330
●
Chapter 11.2.2.9, "STATus:QUEStionable:FREQuency Register" , on page 331
●
Chapter 11.2.2.10, "STATus:QUEStionable:LIMit Register" , on page 332
●
Chapter 11.2.2.11, "STATus:QUEStionable:LMARgin Register" , on page 332
●
Chapter 11.2.2.12, "STATus:QUEStionable:POWer Register" , on page 333
●
Chapter 11.2.2.13, "STATus:QUEStionable:TEMPerature Register" , on page 334
●
Chapter 11.2.2.14, "STATus:QUEStionable:TIMe Register" , on page 334
● General Status Register Commands .................................................................... 687
● Reading Out the CONDition Part .......................................................................... 688
● Reading Out the EVENt Part .................................................................................688
● Controlling the ENABle Part ..................................................................................689
● Controlling the Negative Transition Part ............................................................... 689
● Controlling the Positive Transition Part ................................................................. 690
12.12.1 General Status Register Commands
STATus:PRESet
.............................................................................................................687
STATus:QUEue[:NEXT]?
................................................................................................ 688
STATus:PRESet
This command resets the edge detectors and
ENABle
parts of all registers to a defined
value. All
PTRansition
parts are set to
FFFFh
, i.e. all transitions from 0 to 1 are
detected. All
NTRansition
parts are set to 0, i.e. a transition from 1 to 0 in a
CONDition
bit is not detected. The
ENABle
part of the
STATus:OPERation
and
STATus:QUEStionable
registers are set to 0, i.e. all events in these registers are not
passed on.
Usage: Event
Using the Status Register