Quest Engineering MPS 3, Руководство по эксплуатации, Страница: 79 / 268

MPS 3 System – System Installation
5.6.3. Connecting the Electrocardiogram (ECG) Cable
The MPS 3 System can be connected to a third party Electrocardiogram (ECG) to
display the ECG signal on the MPS 3 Controller. Because there are a variety of ECG
systems, please consult your sales representative to determine which ECG Cable is
needed for your setup.
To connect the ECG Cable to the MPS 3 System, please follow the following steps.
1. Verify that the ECG is compatible with the MPS 3 System. The ECG port of the
MPS 3 System is designed to be used with a ¼ ” Phono ECG cable.
2. Verify that the ECG Cable provided has the correct connections for your ECG
system.
3. Connect the ECG Cable to the appropriate port on the ECG system.
4. Remove the supplied cover from the ECG port. Retain the cover for use if the
cable is to be removed.
5. Connect the ECG Cable to the analog ECG port on the rear panel of the MPS
3 Controller.
Figure 35: ECG Port on MPS 3 Controller
Before connecting the MPS 3 System to the
Electrocardiogram (ECG), consult the ECG Operations
Manual / User Manual to ensure the MPS 3 System is
compatible and can be safely connected.
Avoid OPERATOR INJURY. Only qualified technicians
should connect the ECG Cable to the MPS 3 System. Ensure
that all fingers are free from pinch / crush hazards while
connecting the ECG Cable.
The MPS 3 System does not measure, detect, or interpret
the ECG Signal from the patient leads. The MPS 3 System
only displays the analog ECG output signal from the ECG
equipment.
37
ECG Port