Quest Engineering MPS 3, Руководство по эксплуатации, Страница: 262 / 268

MPS 3 System – Appendix
device behavior which may be caused by such radiation. The MPS 3 System is intended for use in the
electromagnetic environment specified in the tables below.
17.1.1.Electromagnetic Emission
17.1.2.Electromagnetic Immunity
Guidance and Manufacturer’s Declaration – Electromagnetic Emissions.
The MPS 3 is intended for use in the electromagnetic environment specified below. The customer or the
operator of the device should assure that the device is used in such an environment.
Emissions Test Compliance Electromagnetic Environment - Guidance
RF emissions
CISPR 11
Group 1
The MPS 3 System uses RF energy only for its internal
function. Therefore, its RF emissions are very low and
are not likely to cause any interference in nearby
electronic equipment.
RF emissions
CISPR 11
Class B
The product is suitable for use in all establishments,
including domestic establishments and those directly
connected to the public low-voltage power supply network
that supplies buildings used for domestic purpose.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage fluctuations/
Flicker emissions
IEC 61000-3-3
Complies
Guidance and Manufacturer’s Declaration – Electromagnetic Immunity
These devices are intended for use in the electromagnetic environment specified below. The customer
or the operator of the device should assure that the device is used in such an environment.
Immunity test IEC 60601-2, 4th Ed. Test
Level
Compliance level Electromagnetic
Environment Guidance
Electrostatic
discharge
(ESD)
IEC 61000-4-2
±8 kV contact
±2, ±4, ±8, ±15 kV air
±8 kV contact
±2, ±4, ±8, ±15 kV air
Floor should be wood,
concrete or ceramic tile. If
floors are covered with
synthetic material, the
relative humidity should be
at least 30 %
Electrical
transients /
bursts
IEC 61000-4-4
±0.5, ±1, ±2 kV - 100kHz
repetition frequency
±0.5, ±1, ±2 kV -
100kHz repetition
frequency
Mains power quality should
be that of a typical
commercial and/or hospital
environment
Surge
IEC 61000-4-5
± 1 kV differential mode
± 2 kV common mode voltage
± 1 kV differential
mode
± 2 kV common
mode voltage
The quality of the line power
supply should be that of a
typical commercial or
hospital environment.
2