Quest Engineering MPS 3, Руководство по эксплуатации, Страница: 59 / 268

MPS 3 System – System Installation
7. Install the ½ ” Tubing supplied with the Hose Kit to the Reservoir Inlet and
Outlet and secure the tubing with a hose clamp. Route the tubing of the
Reservoir Inlet up through the bracket.
Figure 17: Install Tubing to Reservoir
8. Install the 3/8” Tubing supplied with the Hose Kit to the Reservoir port labeled
“Drain” and secure the tubing with a zip ties.
9. Measure and cut the drain tubing to the desired length and insert the drain
valve into the end of the tubing and secure with a zip tie. Ensure the drain
valve is closed by pressing the button on the top of the drain valve.
10. Measure and cut the inlet and outlet tubing to the desired length. Ensure the
tubing length is long enough to reach the console, but not too short to cause
kinks or stress the connectors or too long to create a trip hazard.
11. Install one female Hansen fitting into the Reservoir Outlet – Console Inlet
tubing and secure with a hose clamp. Insert the other female Hansen fitting into
the Reservoir Inlet – Console Outlet tubing and secure with a hose clamp. Flow
directional arrows may be applied to the tubing to help prevent accidental
misconnections.
Figure 18: Install Hansen Fittings
17
To R
eservo
ir Inl
et
To R
eservo
ir Ou
tlet
To C
onso
le In
let
To C
onso
le O
utle
t