Quest Engineering MPS 3, Руководство по эксплуатации

Страница: 37 / 268

MPS 3 System – Warnings and Cautions
•
The disinfection procedure contained in this Manual has been validated. To reduce the
risk of microbiological contamination, operators should clean and disinfect the device
according to the instructions contained in this Manual.
•
The long-term effectiveness of the MPS 3 circulation system disinfection procedures, the
supplemental use of hydrogen peroxide to inhibit bacterial growth in between disinfection
cycles, and the recommended interval for disinfection were evaluated in the MPS 2 for up
to 6 months, and although biofilm formation is mitigated, it is not prevented.
•
DO NOT USE any sharp edged or hard objects on the display panel. Touch the screen
with your finger to ensure normal operation.
•
Operate the panel in a steady environment. Abrupt variation in temperature and humidity
may cause malfunction of the panel.
•
Avoid high voltage and/or static charge on MPS 3 Controller.
•
If the buttons on the controller do not respond to operator’s input, it needs to be cleaned.
Clean the MPS 3 Controller screen as indicated in MPS 3 cleaning instructions. If the
problem persists, contact Quest Medical customer support.
•
Ensure that external port covers are closed when not in use.
•
DO NOT CONNECT anything to the MPS 3 USB port that is not approved by Quest
Medical.
•
Use the Quest provided USB memory device solely for the MPS 3. DO NOT USE this
USB memory in other devices or computers not approved for use with the MPS 3
System. Add the Quest supplied USB memory device to your organization’s IT security
program.
•
DO NOT CHANGE the file format or directory structure in USB storage device. MPS 3
ONLY recognizes pre-defined formats.
•
A Flow rate number that is flashing is indicative of conditions that are less than ideal to
attain the desired flow rate. Ensure that the inlet lines are unobstructed and that the MPS
3 is being filled at a rate greater than the delivery rate. If the flow rate display continues to
flash, turn down the flow rate until the flashing stops.
7