Quest Engineering MPS 3, Руководство по эксплуатации, Страница: 230 / 268

MPS 3 System – Troubleshooting
11.5.Console or Controller Swap Out
It is recommended to change out the MPS 3 Console or MPS 3 Controller only if the MPS 3
System becomes unusable after following the corrective actions and troubleshooting
suggestions in Sections 11.3 and 11.4.
Follow the following instructions if a MPS 3 Console needs to be replaced during a case:
1. Stop Flow.
2. Select Shutdown with Alarm Button or Rear Switch.
3. Clamp Source and Delivery Line.
4. Remove Disposable Set from Console.
5. Unplug Power Cord, Console to Controller Communication Cable from Console,
Circulation Inlet and Outlet Lines, and any additional Accessories connected to the
Console Rear.
6. If on Pole Mount, remove Console Pole Mount locking pin from foot.
7. Replace Console.
8. Connect Power Cord, Console to Controller Communication Cable into Console,
Circulation Inlet and Outlet Lines (ensure adequate water in Circulation System),
and any required Accessories.
9. Turn on Console with Rear Switch and Standby Switch. After System Diagnostics is
completed, select SWAP on Alarm 314.
10. Select SAME CNTLR on Alarm 315.
11. Select RESUME CASE for all previous case parameters to be returned.
12. If using a Hypothermic Reservoir, prime the Circulation System by selecting
Temp Settings  H2O Prime. If using a Heater-Cooler Unit, resume flow from
Heater-Cooler Unit.
Follow the following instructions if a MPS 3 Controller needs to be replaced during a case:
1. Stop Flow.
2. Select Shutdown with Alarm Button or Standby Switch on front of Console (hold for
3 seconds and wait for switch to turn orange).
3. Remove Controller from Mounting Arm.
4. Disconnect Console to Controller Communication Cable from Controller and
Accessory cables.
5. Replace Controller.
6. Connect Console to Controller Communication Cable and required Accessories to
new Controller.
7. Turn on Console with Standby Switch (hold for 3 seconds and wait for switch to turn
blue).
8. After System Diagnostics is completed, select SWAP on Alarm 314.
9. Select DIFF CNTLR on Alarm 315.
10. Select NEW CASE to setup parameters either manually or via a protocol.
39