Quest Engineering MPS 3, Руководство по эксплуатации, Страница: 71 / 268

MPS 3 System – System Installation
If the cold water source to be used with the MPS 3 System is a third party Heater
Cooler Unit (HCU), please follow these steps to connect the HCU to the MPS 3
System.
1. Consult the HCU Operation Instructions / User Manual prior to attempting to
connect the HCU to the MPS 3 System the HCU will supply adequate water
flow and water temperatures. DO NOT connect a third party HCU to the MPS 3
System if the maximum HCU water pressure exceeds 25psi.
2. Identify the Inlet and Outlet ports on the HCU cardioplegia water circuit.
Connect ½ ” tubing from the Hose Kit to the Inlet and Outlet connectors on the
HCU.
3. Measure and cut the tubing to the desired length so that it can easily attach to
the MPS 3 Console. Ensure the tubing length is long enough to reach the
console, but not too short to cause kinks or stress the connector or too long to
create a trip hazard.
4. Install hose clamps on the tubing ends. Install one female Hansen fitting
supplied with the Hose Kit into the HCU Outlet – Console Inlet tubing and
secure hose clamp using ¼ ” nut driver. Insert the other female Hansen fitting
supplied with the hose kit into the HCU Inlet – Console Outlet tubing and
secure hose clamp using ¼ ” nut driver. Flow directional arrows may be applied
to the tubing to help prevent accidental misconnections.
Figure 28: Install Hansen Fittings
29
To H
CU
Inlet
To H
CU O
utlet