QubicaAMF Express 294-115-200, Инструкция по эксплуатации, техническому обслуживанию и запасным частям

Страница: 50 / 138

Express Lane Machine Operation, Maintenance, and Parts Manual
3-12 Rev. Date: 01/07 400-294-002
4. Position the buffer brush linkage as follows:
•
To increase the buffer brush pressure, move the buffer brush linkage toward
the Vac Head.
•
To decrease the buffer brush pressure, move the buffer brush linkage
toward the oil tank.
5. Tighten the screws.
6. Check the buffer pressure and repeat adjusting the screw positions as needed.
7. Reinstall the hood.
TIP
Make small, incremental adjustments to the buffer brush position and repeat the
pressure tests after each adjustment until you get the pressure set where you want
it.
3.3.2 Rotating The Wicking Foams
Whenever the Express starts leaving a wavy oil pattern, you need to replace the wicking
foam surface. This can be done by replacing the foams or by rotating the wicking foam so
a new surface is applying oil to the oil transfer roller. For information about replacing the
wicking foams, refer to the instructions later in this section. Follow the steps below to rotate
the wicking foams.
NOTES
The Express cannot be used for approximately 15 minutes after you rotate the
wicking foams. This waiting period is required to allow the oil to completely saturate
the wicking foam after being removed from the oil tank tray.
When you use the Express after rotating the wicking foams, clean, oil, and buff the
first lane twice to ensure the proper amount of oil is applied.
To rotate the wicking foams, perform the steps below. Perform these steps with the
machine in the
operating position.
Tools Needed: None
Refer to Drawing Number:
•
294-115-032, View C
•
294-115-085
1. Unfasten the clasps of the oil tank compartment and open the compartment.
2. Slide the oil tank latch sideways out of the slot in the retaining bracket to release
the oil tank.