Operation
400-294-002
Rev. Date: 01/07
2-17
Follow the steps below to fill the oil tank.
1.
Unhinge the clasps
holding the oil tank
cover to the hood, as
shown in figure 2-15
and open the oil tank
compartment door to
access the oil tank.
2.
Remove the plug from
the oil tank and set it
aside.
3. Insert
the
small
red
funnel (it has a filter)
into the opening. Leave
a small gap to allow air to exit from the tank as you fill it.
4.
SLOWLY pour Reactor Oil (or equivalent) into the tank until the oil level in the oil
level indicator, as shown in Figure 2-17, is at the top mark.
5.
Remove the funnel.
6.
Replace the plug.
7.
Wipe up any drips or spills that may
have occurred.
8.
Close the oil tank cover and redo the
clasps.
Because bowlers can slip and fall on oil spilled
on the approach, do not fill the oil tank on the
approach. Fill it 2 to 3 feet down the lane or in an
area away from the lanes, such as the service
area by the pinspotters.
Avoid splashing the oil. Follow all instructions
and precautions on the product label.
Figure 2-15
Figure 2-17
Содержание Express 294-115-200
