QubicaAMF Express 294-115-200, Инструкция по эксплуатации, техническому обслуживанию и запасным частям

Страница: 24 / 138

Express Lane Machine Operation, Maintenance, and Parts Manual
2-10 Rev. Date: 01/07 400-294-002
continually testing for a change in height where the lane drops off. When the sensor
detects the drop off, it sends a signal to the machine that it has reached the end of the pin
deck.
The rear sensor is located on the back wheel
bracket, as shown in Figure 2-9. It is positioned
so it “looks” ahead and slightly to the left of the
machine. Information from this sensor is used
only when the machine is traveling from the pin
deck to the approach (up the lane). The sensor
is continually testing for changes in height such
as caused by the gutter ramps or where the
gutter abuts the approach. When the sensor
detects the change, it signals the machine that it
has reached the approach.
NOTES
•
When the rear sensor detects something in the gutter, it will assume it is “seeing”
where the gutter abuts the approach. Therefore you should remove items from
the gutters before starting the Express down the lane.
•
To ensure the power cord does not affect the sensors, we recommend you route
the cord as described earlier in this section.
•
If the machine turns off in the middle of an operation, you can resume the
operation from where the machine stopped. For information about restarting the
machine, refer to the Troubleshooting section.
•
Brightly colored gutter ramps may not register with the sensor as quickly as
darkly colored ramps. If you have brightly colored ramps and the machine does
not stop at the approach, refer to the Troubleshooting section for information
about adjusting the sensor position.
Figure 2-9