Express Lane Machine Operation, Maintenance, and Parts Manual
3-32
Rev. Date: 01/07
400-294-002
NOTE
To release the sensor wire from the wire bundle, you can either cut the tie
around the bundle or cut the connector off the end of the sensor wire and pull
the sensor wire out of the bundle.
7.
Thread one of the jam nuts onto the new sensor then place the sensor into the
hole in the bracket.
8.
From under the bracket, thread the other jam nut onto the end of the sensor so the
bottom of the bracket is sandwiched between the two jam nuts. Tighten the jam
nuts until the sensor is secured in the position you want.
9.
Route the wire from the sensor through the hole in the side of the machine to the
connector at the back of the control enclosure.
10. Insert the connector into the housing on the control enclosure.
11. Reinstall the hood.
Содержание Express 294-115-200
