Maintenance
400-294-002
Rev. Date: 01/07
3-31
2.
Locate the sensor on the bracket over
the back, right caster wheel, as shown
in Figure 3-33.
3.
While holding the sensor, unscrew the
bottom jam nut (under the bracket) and
remove it from the sensor. Pull the
sensor up from the bracket. Set aside
the jam nut.
4.
Unscrew the top jam nut and set it
aside.
5.
Follow the sensor wire through the hole in the side of the machine, to the wire
harness, and to the connector at the back of the control enclosure. The connector
is the third one from the right on the bottom row, as shown in Figure 3-34.
NOTE
Since the sensor will not fit through the hole in the side of the machine,
disconnect the wire from the control enclosure and pull it through the hole.
6.
Gently squeeze the outer tabs of the connecter and pull it from the housing on the
control enclosure.
Figure 3-33
Figure 3-34
Approach
Sensor
VacHead
Solenoid
Jumper
Buffer
Motor
Encoder
Brake
Board
Pin Deck
Sensor
Содержание Express 294-115-200
