Maintenance
400-294-002
Rev. Date: 01/07
3-13
3.
Tip the oil tank away from the oil transfer roller to expose the oil transfer roller and
wicking foams area.
4.
Spread clean, dry cloths over all the components, leaving only the wicking foams
and oil tank tray exposed.
5.
Working from one side to the other, remove an outside wicking foam from the oil
tank tray.
6.
Turn the wicking foam side to side. The result will be that the front face becomes
the back face with the top remaining at the top and the bottom remaining at the
bottom, as shown in Figure 3-11. Put the turned wicking foam back into the oil
tank tray. Repeat this step for the other wicking foams. Ensure the wicking foams
line up evenly cross the top, with 1-3/8 inches of wicking foam showing above the
tray edge, and that they are firmly seated in the oil tray.
7.
Wipe up any spills immediately with a clean, dry cloth.
8.
Tip the oil tank back against the oil transfer roller, latch the oil tank in place, close
the compartment door and refasten the clasps.
3.3.3 Lubricating The Chains
Approximately every three months you should lubricate the drive chain and sprocket and
the oil transfer roller motor chain and sprocket with a good quality 80- to 90-weight gear oil.
DO NOT USE GREASE. Be sure to wipe off any excess oil.
Figure 3-11
FRONT
BOTTOM - In Oil Tank Tray
1
TOP
BOTTOM
2
BACK
BOTTOM - In Oil Tank Tray
3
TOP - To Transfer Roller
TOP - To Transfer Roller
Содержание Express 294-115-200
