QubicaAMF Express 294-115-200, Инструкция по эксплуатации, техническому обслуживанию и запасным частям

Страница: 66 / 138

Express Lane Machine Operation, Maintenance, and Parts Manual
3-28 Rev. Date: 01/07 400-294-002
3. Make the position changes in small increments.
•
To position the sensor so the distance it
“looks” down the gutter is shorter, move
the bracket lower down on the side of the
machine.
•
To position the sensor so the distance it
“looks” down the gutter is longer, move
the bracket higher up the side of the
machine.
•
To position the sensor so the angle at
which it looks into the gutter is steeper,
rotate the front of the bracket down.
•
To position the sensor so the angle at
which it looks into the gutter is broader,
rotate the front of the bracket toward the
top of the machine.
4. Tighten the bolt just enough to hold the sensor in place then run the Express to
test the positioning.
5. If the machine comes up the lane and turns off only at the approach, fully tighten
the bolt to secure the rear sensor in place. If the Express stops before it reaches
the approach, repeat these steps until the sensor is correctly positioned.
3.4.7.2 Replacing The Front Sensor (Pin Deck)
To replace the front sensor, complete the steps below. Perform these steps with the
machine in the
operating position.
Tools Needed:
•
Phillips screwdriver
•
Wire cutters
Refer to Drawing Number: 294-115-053, View C
4. Remove the screws on each side of
the hood, as shown in Figure 3-29,
and lift the hood off the frame. Set
aside the screws.
Figure 3-28
Figure 3-29