QubicaAMF Express 294-115-200, Инструкция по эксплуатации, техническому обслуживанию и запасным частям

Страница: 65 / 138

Maintenance
400-294-002 Rev. Date: 01/07 3-27
4. From the side opening, hold the divider plate in position and reinstall the top cover.
The screws must pass through the divider plate into the base of the control
enclosure. (You can fasten the screws in whatever order you want, but you may
find it easier to fasten the screw farthest away from the side you have open then
fasten the screw by the side you have open.)
5. Fasten the two screws on the top of the control enclosure.
6. Reinstall the side plate and secure it with the three screws.
7. Reinstall the hood on the frame and secure it in place with the two screws on each
side.
3.4.7 Repositioning And Replacing Sensors
The sensors control where the Express stops. If they are not functioning properly, the
Express may stop before it reaches the approach or may not stop at all. The information
below tells you how to reposition the rear sensor and how to replace the front and rear
sensors.
3.4.7.1 Repositioning The Rear (Approach) Sensor
If you have brightly colored gutters or a structure near the gutter area, the rear sensor may
turn off the Express before it reaches the foul line. To correct this, you can reposition the
sensor.
Complete the steps below to adjust the position of the rear sensor. Perform these steps
with the machine in the
operating position.
Tools Needed:
•
Phillips screwdriver (magnetic tip recommended)
Refer to Drawing Number: 294-115-109
1. Locate the sensor on the bracket
over the back, right caster wheel,
as shown in Figure 3-27.
2. Loosen the bolt just until you can
move the bracket. DO NOT
REMOVE THE BOLT. The sensor
bracket rotates and moves up and
down in the slot on the bracket, as
shown in Figure 3-28.
Figure 3-27