Maintenance
400-294-002
Rev. Date: 01/07
3-21
To replace the wicking foams, perform the steps below. Perform these steps with the
machine in the
operating
position.
Tools Needed:
None
Refer to Drawing Number:
•
294-115-032, View C
•
294-115-085
1.
Unfasten the clasps over the oiling components at the back of the Express and
open the compartment.
2.
Slide the oil tank latch sideways out of the slot in the retaining bracket to release
the oil tank.
3.
Tip the oil tank away from the oil transfer roller to expose the wicking foams.
4.
Pull out the wicking foams out from the oil tank slot and put them in a container to
catch the oil.
5.
Wipe up any spills immediately with a clean, dry cloth.
6.
Insert the new wicking foams so they rest on the ledge of the oil tank slot, as
shown in Figures 3-20a. There should be 1-3/8 inches of foam showing about the
edge of the oil tank slot.
If you are using the standard wicking foams, replace them with the short wicking
foams on the outsides and the long wicking foam in the middle, as shown in Figure
3-20b. If you are using alternate wicking foams, replace the foams according to
your pattern.
Side View
Figure 3-20a
Figure 3-20b
Short
Short
Long
1-3/8”
Содержание Express 294-115-200
