Express Lane Machine Operation, Maintenance, and Parts Manual
3-6
Rev. Date: 01/07
400-294-002
Figure 3-4
TIP
Once you are familiar with the drive
motor connector location, you can
access it through the cutout in the
housing for the waste tank, as shown in
Figure 3-4.
Drive
Motor
Transfer
Roller Motor
and Cleaner
Pump
Vacuum
Motor
Oil / Buffer
Solenoid
4.
Gently squeeze the outer tabs of the drive motor connector and firmly pull it out
from the control enclosure until it releases.
5.
Plug the Express into a power source.
6.
Press the POWER toggle switch to ON.
7.
If it is not already set to OFF, set CLEANER to OFF.
8.
If it is not already set to OFF, set OIL to OFF.
9.
If it is not already set to ON, set BUFF to ON.
10. Press the START key twice.
11. From the rear of the machine, position the vinyl strip of the Pressure Adjusting Tool
under the middle of the buffer brush, with at least 3 inches of the vinyl strip
extending from the other side of the buffer brush. (You will feel it engage under the
buffer brush.)
12. While observing the scale, hold the aluminum plate just off the surface of the lane,
and slowly pull the tool away from the machine until you eventually pull it out from
under the machine.
•
Pull the tool away from the brush in a straight path without lifting the
aluminum plate away from the lane.
•
Take the reading while you are pulling the tool, not as the vinyl strip
releases from the buffer brush.
13. Repeat the test at the left and right sides of the buffer brush.
14. Turn off the machine.
15. If all the readings are not between B and C, you need to reposition the buffer brush
until the buffer brush pressure is the same at each test point across the width of
the brush. For instructions about how to perform this task, refer to the Adjusting
The Buffer Brush Pressure information later in this section.
If the readings are between B and C for all of the areas you tested, unplug the
Express from a power source.
16. Reinstall the drive motor connector into the control enclosure.
17. Reattach the hood to the frame.
Содержание Express 294-115-200
