Quantum SDLC 2.7, Руководство по установке

Страница: 55 / 152

Installation Guide 49
• DB backup to RAID
• DB backup to floppy
• clients configured and tested
• hardware configured and tested
• email address settings
• contact information
• client type(s)
• target card model
• License
• Node1 SID
• Node1 license string
• Node2 SID
• Node2 license string
Common Setup Notes
• If changes are made to the RAID or it is powered off/on a Hard Disk Changed message may appear
during reboot.
• F1 to enter bios
• Esc without making changes
• OK
• The above will also happen when using a Jump Drive.
• If a Jump Drive is in the USB during boot up an invalid disk error may happen
• Reset the time when finished with the installation.
• If the RAID is not new initialize it before starting it. The whole procedure takes approximately 6
hours.
• WinZip needs to be installed and is not by default
• Leave RAID off for a minimum of 20 seconds before powering back on
• Hang on boot up at ATI Rage SDRAM Bios is not an uncommon condition
• Immediately after the install is finished, if the cluster groups do not move from Node1 to Node2,
shutdown Node1 and restart Node2. Make sure that Scalar DLC goes online for Node2, then restart
Node1.
• SqlServerAgent service should be adjusted to use SDLC logon account, instead of using
LocalSystem account. The form should be: <ClusterName>\SDLC (this can be taken from SDLC
service parameters). This adjustment should be performed on both nodes.
• Set the event logs to overwrite when necessary. They will fill up often otherwise.
• If the Ethernet card is installed with Wake on Lan Feature, disable it.
• Typical user account security policy requires the password more than 6 symbols long and contained
both numbers and letters in both small and capital.