Installation Guide
131
Advanced Setup Instructions
This section contains the topic on extended setup not covered in previous chapters.
•
Setting Up the Library
on page 131.
•
Host/Library Communication using Fibre Channel and SNC
on page 135.
•
Building Client Connections
on page 139.
•
Installing SCSI/FC Target Adapters on a Live Machine
on page 142.
•
Securing the Scalar DLC
on page 143.
Setting Up the Library
The following instructions applies to setting up the library media changer. The procedure can be done in any
time when setting up the Scalar DLC, but before installing the Scalar DLC software itself.
Step 1
Set up the library according to the media that will be used.
•
For the 6-symbols barcode, set the Media ID to
disabled
. The library scanner cannot determine
different media of a single domain (for example, DLT IV or SDLT), so the media type-default-by-
domain will be assigned (for example, all DLT media will be recognized as DLT IV). Refer to the
library
Operator Guide
for the details.
•
For the 7-symbols barcode, set the Media ID to
enabled
. The library scanner will read the media
type directly from barcode. Use the library Operator panel,
Main > Setup > Library > Media
, then set:
•
Volser: MEDIA ID
•
Add ID: N
•
Mixed: Y
•
Extend: N
•
ASCQ: N
CAUTION
Do not use different media of a single domain in this type of library. A
hardware crash is otherwise possible.
A hardware crash is also possible if the default media type is not properly
resolved (for example, DLT media resolved as DLT IV, but the real cartridges
are DLT III).
Содержание SDLC 2.7
