24
Setting Up the Scalar DLC
•
Press “Esc”.
•
Select “Configure / view SCSI settings”.
•
Set SCSI controller ID (14 for Node1 and 15 for Node2).
•
Set SCSI termination to
Automatic.
•
Go to
Advanced configuration
.
•
Set “Reset SCSI bus at IC Initialization” to
Disabled
.
•
Set “SCSI controller Int 13 Support“ to
Disabled: NOT scan
.
•
Press “Esc”.
•
Go to “SCSI device configuration” (see
Figure 10
on page 21).
Figure 8
Adaptec SCSI Bios: SCSI Device Configuration
•
Set “Sync Transfer Rate” to 40
•
Set “Start unit command” to
No
for #0.
•
Set “Include in Bios scan” to
Yes
for Node1 and
No
for Node2 for #0.
•
Press “Esc”, and “Esc”, and “Save changes”.
•
Press “Esc”.
•
Select A for library configuration
•
Select “Configure / view SCSI settings”
Note
Rate is 160 for L and P series RAIDs
Содержание SDLC 2.7
