Quantum SDLC 2.7, Руководство по установке

Страница: 46 / 152

40 Setting Up the Scalar DLC
Step 5 Set computer name.
• Right click “My Computer” and select “Properties”.
• (on Windows 2000) Open “Network Identification” and select “Properties”.
• (on Windows 2003) Open Computer Name > Change > More. Ensure that the checkbox
‘Change primary DNS suffix when domain membership changes’ is
enabled (see Figure 11
on page 23). Press OK.
• Set “Computer name” (sdlc1 for Node1 and sdlc2 for Node2)
• Press “OK” and “OK” to reboot and “OK” and “No” to reboot server.
Step 6 Restart Node1.
Step 7 Repeat steps 1 to 6 for Node2.
Step 8 Shutdown Node2.
Configuring Domain Controllers
Under WIndows 2000 Advanced Server and Windows 2003 Server, this procedure is not quite the same.
Windows 2000
Step 1 Configure Primary domain controller (Node1)
• Power on Node1 and log in. In “Configure your server” window select “Active Directory”.
• Select “Start the Active Directory Wizard” and “Next”.
• Select “new domain” and “next”.
• Select “create new domain tree” and “next”.
• Select “create new forest of domain trees” and “next”.
• Enter domain name (sdlcdomain.int) and next.
• Accept short NetBIOS name and next
• Accept default locations and next.
• Accept default folder location and next
CAUTION
Both Node1 and Node2 names must not be longer than 14 symbols.
CAUTION
Using Start > Run do the following:
From Node2 run: ping <Node1 public IP address>
From Node2 run: ping <Node1 private IP address>
From Node1 run: ping <Node2 public IP address>
From Node1 run: ping <Node2 private IP address>
If any of these commands returns “Request timed out“ response, that means
the network settings are configured incorrectly, for example, the network
connection that has been configured as ‘public’, is in fact internal cluster
(private) network connection.