26
IS125 Conveyors | Installation & Maintenance Instructions
Belt Change
u
Removal of Existing Belt
>
For wide and short conveyors, it may be necessary to remove Bearing Plate and Drive Pulley to remove belt. Instructions can be found in drive pulley replacement sections of
this manual.
1
Rotate set screw into shaft
until it clears frame.
2
Rotate tail assembly 180
degrees to remove belt
tension.
3
Remove tail assembly
from frame.
4
Remove torx head screws
from stand brackets or
mounts on opposite side of drive
motor. (If stand brackets are not
used, proceed to step 7)
5
Loosen hex head bolts on
same side.
6
Slide mounting brackets
down to allow clearance
for belt removal.
7
Slide belt over drive end
making sure to clear drive
pulley and bearing plate.
To see a video of this process, scan this code on
your phone or tablet. You may also visit
http://bit.ly/125beltchange
