IS125 Conveyors | Installation & Maintenance Instructions
5
Stand Installation
Mounting Aluminum Stands to Conveyor
u
Mounting Aluminum Exact Width Stands
1
Using a 13mm wrench,
remove the nuts holding the
stand attachment brackets to the
top of the stand and remove the
brackets.
2
Insert torx head thread
forming screws through
bracket and into accessory holes
(2 per side). Flange on stand
attachment bracket should point
outboard for conveyors 6” wide
or less and inboard for conveyors
more than 6” wide.
3
Place stand attachment
brackets atop stands.
4
Replace nuts and tighten
using a 13mm wrench.
u
Stand Height Adjustment
1
Loosen two lower screws in
each stand bracket using a
5mm allen wrench.
2
Adjust stand height by
turning bolt using a 3/4”
wrench. Turn clockwise to lower or
counter-clockwise to raise. Ensure
conveyor is level.
3
Tighten jam nut against top
plate of stand.
4
Tighten two lower screws in
each stand bracket using a
5mm allen wrench.
