16
IS125 Conveyors | Installation & Maintenance Instructions
Drive Packages
The Drive Package will ship separate from the conveyor with the speed reducer attached, and the speed reducer’s sprocket already attached to its shaft. For Standard Duty and
Pneumatic Drives, the speed reducer and motor will ship installed on the drive mounting package. For Heavy Duty Drives, the motor is always shipped in its own box; the right
angle speed reducer will be attached to the drive mounting package.
QC Conveyors recommends that all wiring be completed by a certified electrician to ensure correct installation. Refer to documentation contained in the motor’s box for
instructions on electrical connections.
u
Side Drive Mounting Package
2
x
2
x
1
Loosen tracking screw from
anvil block.
2
Remove two hex nuts and
anvil block. Discard anvil
block.
3
Remove screws from drive
mounting plate.
4
Place drive mounting plate
over conveyor‘s spacer
block studs.
2
x
5
Secure plate with two hex
nuts.
6
Rotate drive pulley so key is
in 12 o’clock position.
7
Remove tape from key and
shaft.
Do NOT remove key.
8
Rotate speed reducer key-
way to 12 o’clock position.
