IS125 Conveyors | Installation & Maintenance Instructions
29
Bearing Replacement
u
Bearing Assembly Replacement
>
Remove drive package. (Follow steps for your drive package in Drive Package section of this manual in reverse order)
>
Release tension at tail end. (Follow steps in Idler Pulley Replacement section of this manual)
2
x
1
Loosen tracking screw
from anvil block.
2
Remove two hex nuts and
anvil block.
3
Slide old bearing assem-
bly off drive pulley.
4
Slide new bearing assem-
bly onto drive pulley.
2
x
5
Re-install anvil block and
two hex nuts.
6
Tighten tracking screw into
anvil block.
>
Re-tension tail. (Follow steps in Idler Pulley Replacement section of this manual)
>
Re-install Drive package. (Follow steps for your drive package in Drive Package section of this manual)
If tensioning adjustment is needed, refer to belt tensioning section of this manual.
If Tracking adjustment is needed, refer to belt tracking section of this manual.
