18
IS125 Conveyors | Installation & Maintenance Instructions
u
Top and Bottom Drive Mounting Packages
1
Remove flat head screw
from bearing plate.
2
Loosen tracking screw from
anvil block.
3
Remove hex nut from anvil
block.
4
Remove anvil block and
discard.
5
Remove plastic guard from
mounting package by loos-
ening socket head screws.
6
Mount drive mounting plate
over conveyor shaft and
spacer block stud.
7
Insert and tighten flat head
screw in drive mounting
plate.
8
Replace and tighten hex
nut.
9
Remove tape from
conveyor’s shaft.
Do NOT
remove key.
10
Loosen three socket
head cap screws.
11
Thread jacking screw
in to allow sub plate to
move toward conveyor.
12
Slide top sprocket onto
conveyor’s shaft key so
it is flush with end of shaft.
