28
IS125 Conveyors | Installation & Maintenance Instructions
u
Belt Tension
Belt does not have enough tension when it doesn‘t move under load or sags below frame.
Belt has too much tension when pulley begins to bow inward towards frame.
4
x
2
x
4
x
1
Loosen all four driver as-
sembly screws.
2
Rotate tracking screws in to
decrease tension or out to
increase tension. (Tracking screw
on both sides should be extended
same amount.)
3
Tighten all four driver as-
sembly screws.
If additional belt tension is needed after following these steps and solutions found in the Troubleshooting section of this manual, it is recommended that a new belt be
installed.
u
Belt Care / Cleaning
1
Inspect Belt for any fraying
or tears and replace if
needed.
2
Spray cleaning solution on
a clean rag.
3
Wipe belt with rag.
4
Cycle conveyor to reveal
opposite side of belt.
5
Wipe belt with rag.
