14
IS125 Conveyors | Installation & Maintenance Instructions
Side / Guide Installation
Adjustable Guides
u
Installing Adjustable Guide Brackets
For guides used with Top Drive Mounting Packages, Guiderail may need to be installed 3” down conveyor, as there will be interference between Guiderail and Drive Mounting
Plate; this will cause guides to extend 3” beyond end of conveyor.
>
For 1” guides, skip step four. Hex head screws are already installed.
1
Attach guide brackets to
conveyor no more than 24”
apart, evenly spaced using 7/8”
thread forming torx head screws.
(Can be attached over stand
brackets)
2
Insert vertical rods into
each guide bracket.
3
Secure each rod with ½”
hex head screws and ¼”
lock washers.
4
Slide ¼” hex head screws
into tee slot of guiderail.
5
Thread adjusting rods onto
hex head screws.
Do NOT
Tighten.
6
Slide a cross block over
each adjusting rod.
7
Install guiderail and block
assembly over vertical rods.
8
Tighten guide bars to guide
rail.
9
Adjust guides to desired
width and tighten screw.
10
Adjust guide to desired
height and tighten block
assembly to vertical rod. (Guide
should
NOT
touch belt)
