PowerBoss Admiral 48D, Инструкция по эксплуатации

Страница: 97 / 120

97
Maintenance and Service
7. Open the recovery tank lid
(Fig. 31/1).
8. Flush the recovery tank with water
filled from the top through the open
tank lid.
Cleaning may only be carried
out using a water hose
(operating pressure approx.
72.51 to 87.01 psi) and only
from top to bottom. Do not aim
the jet of water directly at
openings, slits, electronic
components, operating panels
or seals.
It is not permitted to clean the
vehicle with a high-pressure
washer or with a steam blaster
because the temperature is in
excess of 212 °F.
Wear appropriate gloves for
protection against dirt, viruses,
bacteria etc. when cleaning the
container.
9. After finishing cleaning the tank,
close the flap and push the run-off
plate back in place.
10.Unhook the waste water draining
hose (Fig. 31/6), lower it slowly and
open the cap (Fig. 31/5).
11.Run fresh water in the recovery tank
through the open lid using a water
hose (output pressure approx. 72.51
to 87.01 psi) and, in doing so, also
flushing the draining hose (see
above).
12.Screw the cap shut again and hook
the draining hose back in place.
13.Close the rear panel frame.
14.Close the left and right rear doors.
The cleaning flap must not be
used to drain off waste water.
5.6.3 Cleaning the draining hose
cap
• Clean the screw cap on the waste
water draining hose (Fig. 31/6) daily.
• Lubricate the O-ring lightly, if
necessary.