PowerBoss Admiral 48D, Инструкция по эксплуатации

Страница: 53 / 120

53
Operation
Recovery tank
(Fig.
23/2+5)
The air intake filter (Fig. 23/2) is located
under the recovery tank lid (Fig. 23/5) at
the top of the recovery tank and is
connected to the end of the suction
pipe. It prevents coarse dirt getting into
the suction turbines and must be
checked or cleaned daily, refer to
Section 5.6.4.
Fresh water tank
(Fig.
23/3+6)
In order to fill fresh water and cleaning
agent, pivot up the lid of the fresh water
tank (Fig.
23/6) and lock it. The tank is
filled through the filling neck (Fig. 23/3),
refer to Section 5.5.1.
Lid lock
(Fig.
23/4)
The lock prevents the lid falling shut. To
lock the lid, move the bar and latch in
place. To release the lock, raise the lid
a little and pivot the lock back a little.
The lid lock functions in the same way
on the fresh water tank and recovery
tank.
Rear doors
(Fig.
23/7+9)
Open the rear doors to access the
draining hoses for waste water and
fresh water.
Waste water draining hose
(Fig.
23/11)
The draining hose for waste water
hooked is in the left-hand rear door.
Only drain off waste water through this
hose at an appropriate location, refer to
Section 5.6.1.
Fresh water draining hose
(Fig.
23/10)
The draining hose for fresh water hangs
to the left of the suction turbines. Only
drain off the fresh water through this
hose at an appropriate location, refer to
Section 5.5.2.
Rear panel frame
(Fig.
23/8+12)
In order, for example, to access the flap
to clean the recovery tank, the rear
panel frame must be opened. To do
this, pull the lock lever (Fig.
23/12) up
and open the unlocked rear panel frame
(Fig.
23/8).