PowerBoss Admiral 48D, Инструкция по эксплуатации, Страница: 63 / 120

63
Operation
3.5 Function faults
The following applies when
locating and clearing faults:
Switch the vehicle off, remove
the key from the key switch
and disconnect the battery
plug!
3.5.1 Error code table
In the case of system errors, a four-digit
error code appears in the left-hand
operating panel in addition to the
service indicator (wrench symbol).
The dots in the error/service code flash.
Clear the fault or note down the
error/service code and inform your
authorized PowerBoss dealer.
Error code Fault Cause Solution
1.2.5.2. Brushes remain stopped
because the thermostatic
switch has been tripped.
The motor has overheated;
foreign bodies have possibly
jammed between the brush and
shaft (e.g. tape and such).
• Check the brushes for foreign bodies
and remove them, as necessary.
• Allow the motor to cool down.
• If the problem reoccurs, determine the
cause of overheating; contact an
authorized PowerBoss service center, if
necessary.
1.2.5.5. Brushes remain stopped
because the thermostatic
switch of the third, middle
brush has been tripped.
The motor has overheated;
foreign bodies have possibly
jammed between the brush and
shaft (e.g. tape and such).
• Check the brush for foreign bodies,
remove them as necessary.
• Allow the motor to cool down.
• If the problem reoccurs, determine the
cause of overheating; contact an
authorized PowerBoss service center, if
necessary.
1.2.6.1. Brushes remain stopped
because the anti-blocking
system has been tripped.
Foreign bodies (e.g. tape or
such) block the brushes
• Check the brushes for foreign bodies
and remove them, as necessary.