PowerBoss Admiral 48D, Инструкция по эксплуатации

Страница: 105 / 120

105
Maintenance and Service
Emptying the dirt hopper
Observe the applicable laws
and local regulations in respect
of disposal!
Empty the content of the dirt hopper
(Fig.
38/2) in a waste container at
regular intervals.
Installing the dirt hopper
1. Take hold of the dirt hopper
(Fig. 38/2) in both hands using the
grips located at the sides of the dirt
hopper (Fig.
38/2).
2. Fit the dirt hopper (Fig. 38/2) in the
guide rails, slide in as far as possible
and press the dirt hopper (Fig.
38/2)
upwards until the lock audibly
latches into place.
If the dirt hopper (Fig. 38/2) is
not properly engaged, the “Dirt
hopper and front flap indicator
of the pre-sweep/vacuum unit”
lamp (Fig.
21/3) lights up. The
pre-sweep/vacuum unit does
not work.
5.9.2 Dust vacuum
The filter system of the dust vacuum
(use category "U") is located in the filter
case above the dirt hopper (Fig.
38/2).
The filter case is movable, the
movement linked to that of the dirt
hopper (Fig.
38/2) in order to be able to
shake the filter element (panel air filter)
when the agitating motor is switched
on.
Clearing the panel air filter of dust
during operation
Clean the panel air filter (Fig. 39/2) in
the dust vacuum regularly or as
necessary using the agitating device:
• Press the “Button for agitating
device” (Fig. 22/2).
After pressing the button, an
intermittent agitating process runs for
approx.
6 seconds.
• To end the intermittent agitating
process prematurely, press the
same button (Fig.
22/2) again.
• Alternatively: Turn the key switch to
position 0 or 1 (RESET).
Disassembling the panel air filter
Fig. 39
1 Filter case cover with agitating
motor
2 Filter element (panel air filter)
1. Open the front flap to the front.
The engine must have stopped
before opening the front flap.
Risk of injury!
2. Remove the straps holding the filter
case cover (Fig. 39/1).
3. Remove the filter case cover
(Fig. 39/1).
1
2