- 21 -
0800_GB-Power-Control_2441
GB
POWER CONTROL - OPERATION
Note!
Altering the
respective
configuration
takes place with
the plus and
minus buttons
on the console
Note!
Navigating to
input fields takes
place with the
arrow buttons
on the console
The following menu pages are displayed by pressing the “Menu”
button on the console.
The CONFIG menu comes after the WORK menu.
Config-menu
Calibrating angular sensors
Menu function:
Calibrating angular sensors is necessary through a
sensor exchange. The function serves to memorize
the voltage level at end positions.
a
b
Meanings of Indicators:
a
Lowering time for front rotary units
b
Lowering time for rear rotary units
Adjustment value: 1 – 20 seconds
Testing the lowering time: (depending on tractor)
When all 4 rotors are lowered simultaneously, all cylinders
must be fully extended after the time has expired.
Setting the lowering time from off-road transport to working position
Automatic “Time offset raising and lowering” function
Menu function:
In this menu the buttons “Raise selected rotary units
from working position to off-road position” or “Lower
selected rotary units from off-road position to working
position” can be set up as an automatic function.
Meanings of Indicators:
a
Activating the auto function: On/Off
b
Section for time offset raising
c
Section for time offset lowering
a
b
c
•
Starting the minimum and maximum working widths
is button activated
(The function is only active when the button is
pressed)
For this all rotary units must be in the off-road
position
• Calibration procedure for an angular sensor
- Select required rotary unit
- Press (-) button until stop
- Press “Menu/OK” button for 2 seconds
- Press (+) button until stop
- Press “Menu/OK” button for 2 seconds
- Press ESC button
•
The interval between raising/lowering the front rotors
and raising/lowering the rear rotors is adjusted here.
Note!
This adjustment can only be made in the
working or off-road transport position.
Example: (From working position to off-road position lift by 50%, 100% or 150%)
Note!
The automatic
function can only
be carried out
in the working
position or off-
road transport
position. At
still stand the
automatic
function is
deactivated for
safety reasons!
1
2
2
2
50%
100%
150%
Note!
With a double
click on one
of the buttons
all preselected
rotors are
immediately
activated
