- 19 -
0800_GB-Power-Control_2441
GB
POWER CONTROL - OPERATION
Control panel
Display indicator:
•
WORK
•
CONFIG
TEST
(sensor test)
-
DATA
(software versions, operating hours, Hectare
counter)
Description of the buttons:
1
Raise all rotary units to transport position
2
Lower all rotary units to the off-road transport
position
3
Select - rotary unit front left
4
Select - rotary unit rear left
5
Select - rotary unit front right
6
Select - rotary unit front right
7
Raise selected rotary units from working position
to off-road position
8
Lower selected rotary units from off-road position
to working position
9
Special menu / OK
10
Display of stored values / working width and
working height
11
Load working height (press SHORT button).
Save current working height (press LONG button
-> 5 secs. or until beep)
12
Raking height menu
13 Menu
navigation
14 Menu
navigation
15
Load working height (press SHORT button).
Save current working height (press LONG button
-> 5 secs. or until beep)
17 STOP
18+19 In the navigation: Alter values (-) (+)
In WORK menu: Alter working width of selected
rotary units
In working height adjustment: Alter working height
(raking height) of selected rotary units
20
ESC – return to previous menu (press SHORT
button)
Display
When the machine is turned on, the machine’s current
status is displayed on the work screen
Note!
Always store
control panel in a
weather-resistant
location.
Symbol description:
1 Activated rotary units
2 Current hectare count
3 Current working width
4 Minimum swath width display
3
2
1
1
2
4
6
8
3
5
7
9
11
12
13
14
17
18
15
19
20
10
4
Power control initial operation
Switching control device ON and OFF
Switching on
- Briefly
press
key
Switching off
- Press key for 3 seconds
Note!
After switching
off the control
panel move the
hydraulic servo-
valve (ST) to
the 0 position to
prevent possible
oil overheating!
Note!
Standby power
(400mA) also
flows to a
switched off
control panel.
Disconnect after
operation to save
the battery.
