- 34 -
0900-GB Einsatz_2441
GB
USE
Variant:
Hydraulic height adjustment for rotary unit and
feeler wheel
(only for variant: Power control / ISO bus)
- Press “Adjust working height”
button
With that all rotary units are selected
- Set the required working height with
“Button (+)” or “Button (-)“
- To adjust individual rotary units select
these with the preselect buttons
- Then set the required working height
with “Button (+)” or “Button (-)“
- Set working height to “0” and save (see chapter “ISO
bus terminal, F4)
- The feeler wheel is adjusted simultaneously.
For setting the machine at normal it may
be necessary to adjust the feeler wheel
separately:
- Remove linch pin (V) which breaks the connection
to the rotary unit
- Adjust feeler wheel height using handle. (Handle is
located at end of console to which tine arm is also
fixed.)
- Reconnect using linch pin.
Working without feeler wheel:
- Remove linch pin (V)
- Remove
feeler
wheel
- Lay dumb-bell shaft on bearer (H) and secure with
linch pin (V).
Optional extra: Feeler wheel inside
(For both variants)
The “feeler wheel inside” is set once manually (see
paragraph “Rotor running gear”). Changing the working
height does not affect this setting.
- Loosen
screws
(9)
- Set feeler wheel height using adjusting screw (8)
- Tighten screws (9) again.
