GB
1000_GB-TRANSPORT_2441
- 15 -
TRANSPORT
Attention!
Changing from
working position
to transport
position is only to
be carried out on
even, firm ground.
Make sure that
swivel area is free
and that nobody
is standing in the
danger area.
Changing from transport- to work-position
Variant: Power Control / ISOBUS
• Switching on operating device
• Move servo-valve to (h) – enable oil flow
• Lower rotary units to off-road transport
position using key
• Swing rotary units into working position using
key
• Set working width
- Set working width, see chapter “Operation”
Variant: Standard
• Open all stop valves (pos. E)
• Set servo-valve (ST) to raise briefly to release transport
safety device (T).
• Lower all rotary units using servo-valve (ST)
Tip: Leave the servo-valve (ST) on lower long enough
to allow the hydraulic cylinder to be fully extended.
Only this will guarantee optimum rotor ground
adaptation.
• Set working width
- Set working width, see chapter “Operation”
075-09-05
