- 32 -
0900-GB Einsatz_2441
GB
USE
Working width adjustment
The swather’s working width (A) can be adjusted through
the front rotary units
- With a working width increase the cover between the
front and rear rotary unit becomes smaller
- With a working width decrease the cover between the
front and rear rotary unit becomes larger
Always keep the cover large enough to ensure the harvested
crop is caught even when travelling through curves
Variant without Power Control
Operating with two control devices
- The front rotary units are simultaneously controlled
through the control device
Control device no. 2 = both rotary units
Operating with three control devices
- The front rotary units are independently controlled
through two separate control devices
Control device no. 2 = right rotary unit
Control device no. 3 = left rotary unit
Variant: Power Control / ISOBUS
- Select the required rotary unit with
the selection button
- Set the required working width
with the (+) button or (-) button
Swath width adjustment
The swath width (B) can be altered via the rear rotary
units
Variant: Standard
- Both rear rotary units can only be jointly
controlled
- Pull the rope
- Actuate control device no. 2
Variant: Power Control / ISOBUS
- Select the required rotary unit with
the selection button
- Set the required swath width with
the (+) button or (-) button
A = Working width
B = Swath width
A
B
Attention!
With a combination
of maximum
working width,
small swath width
and tight curves,
strip build-ups
can occur. To
remedy reduce
working width.
