- B1 -
0700_ GB-Gelenkwelle_BA-ALLG
GB
DRIVESHAFT
Supplement - B
Rules for working
Never exceed the ma xi mum p. t. o. speed when using
the implement.
- When the p.t.o. is switched off, the implement hitched
up may not stop at once.
Do not go close to the implement until all motion has
stopped; only then may work be done on it.
- When the implement ist parked, either remove the
driveshaft and store it, or secure it with a chain. Do
not use re tai ning chain (H) for this.
Wide-angle joint:
Maximum angle of de flec tion when working/ stationary :
70°
Standard joint :
Maximum angle of de flec tion when stationary: 90°
Maximum angle of deflection when working: 35°
Maintenance
Replace worn-out covers/guards at
once.
- Lubricate with a brand-name grease be fo re star ting
work and every 8 hours worked.
- Before any extended period of non-use, clean and
lubricate driveshaft.
For winter working, grease the tube guards, to avoid
them free zing together.
Matching driveshaft to tractor
To determine the actual length re qui red, hold the two
halves of the driveshaft side by side.
Procedure for cutting to length
- To determine length re qui red, set implement in clo sest
working position (L2) to trac tor, hold driveshaft hal ves
side by side and mark off.
Important!
• Note the maxi mum operating length (L1)
- Try to attain the greatest possible shaft over-
lap (min.
1
/
2
X)!
• Shorten inside and out si de tube guard by the same
amount.
• Fit torque limiter (2) of drive shaft to implement end of
driveshaft!
• Always check that drive shaft locks are securely
engaged be fo re starting work.
Retaining chain
- Use chain to prevent tube guard from rotating.
Take care that chain does not impede driveshaft
pivo ting.
8
h
FETT
Important!
Only use the indi-
cated or accom-
panying drive
shaft, otherwise
the right to claim
under guarantee
for any possible
damage does not
exist.
